J. Thrinadh, S. Datta, and M. Masanta,"Wear morphology of microwave post-treated WC-Co tool during machining of Inconel 718 superalloy", Materials Today: Proceedings, Elsevier 2020, 10.1016/j.matpr.2020.05.020       Article

K. Pandey, L. A. Rahman, and S. Datta,"Machinability of Inconel 825 superalloy under dry cutting environment with application of uncoated WC-Co tool", Materials Today: Proceedings, Elsevier 2020, 10.1016/j.matpr.2020.05.150       Article

S. S. Bedi, S. P. Sahoo, B. Vikas, and S. Datta,"Influence of cutting speed on dry machinability of AISI 304 stainless steel", Materials Today: Proceedings, Elsevier 2020, 10.1016/j.matpr.2020.05.554       Article

S. K. Sahu, J. Thrinadh, and S. Datta,"Study of machinability assessment of nickel based alloy using electro-discharge machining with transformer oil as dielectric", Materials Today: Proceedings, Elsevier 2020, 10.1016/j.matpr.2020.06.262       Article

S. P. Sahoo and S. Datta,"Dry, MQL, and Nanofluid MQL machining of Ti–6Al–4V using uncoated WC–Co insert: application of jatropha oil as base cutting fluid and graphene nanoplatelets as additives", Arabian Journal for Science and Engineering, pp.1-20, Springer 2020, 10.1007/s13369-020-04849-0       Article

J. Thrinadh, S. Datta, and M. Masanta,"Studies on chip morphology and modes of tool wear during machining of Ti-6Al-4V using uncoated carbide tool: application of multi-walled carbon nanotubes added rice bran oil as nanocutting fluid", Machining Science and Technology, an International Journal, Taylor and Francis 2020, 10.1080/10910344.2020.1815040       Article

J. Thrinadh and S. Datta,"Machinability of Ti-5Al-2.5Sn for electro-discharge machining: an experimental investigation", Sadhana, Springer 2020, 10.1007/s12046-020-01479-y       Article

S. P. Sahoo and S. Datta,"Dry Machining Performance of AA7075-T6 Alloy Using Uncoated Carbide and MT-CVD TiCN-Al2O3-Coated Carbide Inserts", Arabian Journal for Science and Engineering, Springer 2020, 10.1007/s13369-020-04947-z       Article

J. Thrinadh, S. Datta, and M. Masanta,"Study of surface integrity and machining performance during main/rough cut and trim/finish cut mode of WEDM on Ti–6Al–4V: effects of wire material", Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol.41, pp.151, Springer, February 2019, 10.1007/s40430-019-1656-4       Article

M. Kumar, S. Datta, and R. Kumar,"Electro-discharge machining performance of Ti–6Al–4V alloy: studies on parametric effect and phenomenon of electrode wear", Arabian Journal for Science and Engineering, vol.44, no.2, pp.1553–1568, Springer, February 2019, 10.1007/s13369-018-3632-1       Article